Version 7.2 989 Mediant 500L Gateway & E-SBC
User's Manual 66. Testing SIP Signaling Calls
2. Scroll down the page to the area below the table. Statistics of the selected test call are
displayed under the Statistics group, as shown in the example below:
Figure 66-2: Viewing Test Call Statistics
The statistics fields are described in the following table:
Table 66-3: Test Call Statistics Description
Statistics Field Description
Active Calls
Number of currently established test calls.
Call Attempts
Number of calls that were attempted.
Total Established Calls
Total number of calls that were successfully established.
Total Failed Attempts
Total number of call attempts that failed.
Remote Disconnections
Count
Number of calls that were disconnected by the remote side.
Average CPS
Average calls per second.
Elapsed Time
Duration of the test call since it was started (or restarted).
Test Status
Status (brief description) as displayed in the 'Test Status' field (see
''Viewing Test Call Status'' on page 988).
Detailed Status
Displays a detailed description of the test call status:
"Idle": Test call is currently not active.
"Scheduled - Established Calls: <number of established calls>, ASR:
<ASR>%": Test call is planned to run (according to 'Schedule
Interval' parameter settings) and also shows the following summary
of completed test calls:
Total number of test calls that were established.
Number of successfully answered calls out of the total number of
calls attempted (ASR).
"Running (Calls: <number of active calls>, ASR: <ASR>%)": Test call
has been started (i.e., the Dial command was clicked) and shows the
following:
To Next Page
Loading...
