AudioCodes Mediant 500L - Configuring Remote Media Subnets

User's Manual 340 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description

[0] No (default)
 [1] Yes
Note:
 You can configure the parameter to Yes for only one
Media
Realm; all the other Media Realms must be configured to
No.
 If you do not configure the parameter (i.e., the parameter is
No for all Media Realms), the device uses the first Media
Realm in the table as the default.
 If the table is not configured, the default Media Realm
includes all configured media interfaces.
Quality of Experience
QoE Profile
qoe-profile
[CpMediaRealm_QoeProfile]
Assigns a QoE Profile to the Media Realm.
By default, no value is defined.
To configure QoE Profiles, see ''Configuring Quality of
Experience Profiles'' on page 325.
BW Profile
bw-profile
[CpMediaRealm_BWProfile]
Assigns a Bandwidth Profile to the Media Realm.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth
Profiles'' on page 330.
17.1.1 Configuring Remote Media Subnets
Remote Media Subnets define destination subnets for media (RTP/SRTP) traffic on a
specific Media Realm. Each Remote Media Subnet can be assigned different call quality
(Quality of Experience Profile) and bandwidth utilization (Bandwidth Profile) profiles. These
profiles are configured in ''Configuring Quality of Experience Profiles'' on page 325 and
''Configuring Bandwidth Profiles'' on page 330, respectively. Thus, you can apply these
profiles to remote media subnets instead of Media Realms or IP Groups. You can configure
up to five Remote Media Subnets per Media Realm.