AudioCodes Mediant 500L - HTTP Proxy Parameters

Version 7.2 1253 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
HTTPRemoteServices_TLSContext,
HTTPRemoteServices_VerifyCertificate,
HTTPRemoteServices_TimeOut,
HTTPRemoteServices_KeepAliveTimeOut,
HTTPRemoteServices_ServiceStatus;
[\HTTPRemoteServices]
For more information, see ''Configuring Remote Web Services''
on page 282.
HTTP Remote Hosts Table
HTTP Remote Hosts
configure system > http-services
> http-remote-hosts
[HTTPRemoteHosts]
Defines remote HTTP hosts per remote Web service.
The format of the ini file table parameter is as follows:
[HTTPRemoteHosts]
FORMAT HTTPRemoteHosts_Index =
HTTPRemoteHosts_HTTPRemoteServiceIndex,
HTTPRemoteHosts_RemoteHostIndex,
HTTPRemoteHosts_Name, HTTPRemoteHosts_Address,
HTTPRemoteHosts_Port, HTTPRemoteHosts_Interface,
HTTPRemoteHosts_HTTPTransportType,
HTTPRemoteHosts_HostStatus;
[\HTTPRemoteHosts]
For more information, see ''Configuring Remote HTTP Hosts'' on
page 286.
69.13.6 HTTP Proxy Parameters
The HTTP Proxy service parameters are described in the table below.
Table 69-80: HTTP Proxy Service Parameters
Parameter Description
HTTP Proxy Application
configure network >
http-proxy settings >
http-proxy-app
[HTTPProxyApplication]
Enables the HTTP Proxy application.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
HTTP Proxy Debug Level
configure network >
http-proxy settings >
http-proxy-debug-level
[HTTPProxySyslogDebugLevel]
Enables debugging of HTTP services.
 [0] No Debug = (Default) Disable.
 [1] Basic = Enables debug and sends basic information in
Syslog.
 [2] Detailed = Enables debug and sends basic information in
Syslog.
HTTP Interfaces Table
HTTP Interfaces
configure network >
http-proxy > http-
interface
[HTTPInterface]
Defines local listening interfaces for receiving HTTP/S requests
from Web clients for HTTP/S-based services.
The format of the ini file table parameter is as follows:
[ HTTPInterface ]
FORMAT HTTPInterface_Index = HTTPInterface_InterfaceName,
HTTPInterface_NetworkInterface, HTTPInterface_Protocol,
HTTPInterface_Port, HTTPInterface_TLSContext,