AudioCodes Mediant 500L - Packetsmart Parameters; Security Parameters; General Security Parameters

Version 7.2 1039 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
69.3.5 PacketSmart Parameters
The PacketSmart parameters are described in the table below. For more information on
PacketSmart, see ''Configuring PacketSmart for Network Monitoring'' on page 893.
Table 69-21: PacketSmart Parameters
Parameter Description
PacketSmart Agent Mode
configure system >
packetsmart enable
[PacketSmartAgentMode]
Enables the embedded PacketSmart agent.
 [0] Disable (Default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
PacketSmart Server IP
Address
configure system >
packetsmart server
address
[PacketSmartIpAddress]
Defines the IP address of the PacketSmart server with which the
PacketSmart agent communicates.
The default is 0.0.0.0.
PacketSmart Server Port
configure system >
packetsmart server
port
[PacketSmartIpAddressPort]
Defines the TCP port of the PacketSmart server to which the
PacketSmart agent connects.
The default is 80.
Monitoring Interface
configure system >
packetsmart monitor
voip interface-if
[PacketSmartMonitorInterface]
Assigns an IP network interface (configured in the IP Interfaces
table) that handles the voice traffic.
Note: For the parameter to take effect, a device reset is required.
Network Interface
configure system >
packetsmart network
voip interface-if
[PacketSmartNetworkInterface
]
Assigns an IP network interface (configured in the IP Interfaces
table) for communicating with the PacketSmart server. This is
typically the OAMP interface.
Note: For the parameter to take effect, a device reset is required.
69.4 Security Parameters
This subsection describes the device's security parameters.
69.4.1 General Security Parameters
The general security parameters are described in the table below.
Table 69-22: General Security Parameters
Parameter Description
Firewall Table