AudioCodes Mediant 500L - NTP and Daylight Saving Time Parameters

User's Manual 1028 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
server static-ip <index>
[DhcpStaticIP]
The format of the ini file table parameter is as follows:
[ DhcpStaticIP ]
FORMAT DhcpStaticIP_Index = DhcpStaticIP_DhcpServerIndex,
DhcpStaticIP_IPAddress, DhcpStaticIP_MACAddress;
[ \DhcpStaticIP ]
For more information, see Configuring Static IP Addresses for DHCP
Clients on page 227.
69.2.8 NTP and Daylight Saving Time Parameters
The Network Time Protocol (NTP) and daylight saving time parameters are described in
the table below.
Table 69-16: NTP and Daylight Saving Time Parameters
Parameter Description
NTP Parameters
CLI path: configure system > ntp >
For more information on Network Time Protocol (NTP), see ''Simple Network Time Protocol
Support'' on page 129.
Primary NTP Server Address
primary-server
[NTPServerIP]
Defines the IP address (in dotted-decimal notation or as an FQDN) of
the NTP server. The advantage of using an FQDN is that multiple IP
addresses can be resolved from the DNS server, providing NTP
server redundancy.
The default IP address is 0.0.0.0 (i.e., internal NTP client is disabled).
Secondary NTP Server
Address
secondary-server
[NTPSecondaryServerIP]
Defines a second NTP server's address as an FQDN or an IP address
(in dotted-decimal notation). This NTP is used for redundancy; if the
primary NTP server fails, then this NTP server is used.
The default IP address is 0.0.0.0.
NTP Update Interval
update-interval
[NTPUpdateInterval]
Defines the time interval (in seconds) that the NTP client requests for
a time update.
The default interval is 86400 (i.e., 24 hours). The range is 0 to
214783647.
Note: It is not recommend to set the parameter to beyond one month
(i.e., 2592000 seconds).
NTP Authentication Key
Identifier
auth-key-id
[NtpAuthKeyId]
Defines the NTP authentication key identifier for authenticating NTP
messages. The identifier must match the value configured on the NTP
server. The NTP server may have several keys configured for different
clients; this number identifies which key is used.
The valid value is 1 to 65535. The default is 0 (i.e., no authentication is
done).
NTP Authentication Secret
Key
auth-key-md5
[ntpAuthMd5Key]
Defines the secret authentication key shared between the device
(client) and the NTP server, for authenticating NTP messages.
The valid value is a string of up to 32 characters. By default, no key is
defined.
Regional Clock and Daylight Saving Time Parameters