AudioCodes Mediant 500L - Debugging and Diagnostics Parameters

Version 7.2 1029 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
UTC Offset
configure system > clock >
utc-offset
[NTPServerUTCOffset]
Defines the Universal Time Coordinate (UTC) offset (in seconds) from
the local time.
The valid range is -43200 to 43200. The default is 0.
Note: The offset setting is applied only on the hour. For example, if
you configure the parameter at 15:42, the device applies the setting
only at 16:00.
Daylight Saving Time
configure system > clock >
summer-time > summer-time
[DayLightSavingTimeEnable]
Enables daylight saving time (DST).
 [0] Disable (default)
 [1] Enable
Start Time / Day of Month
Start
configure system > clock >
summer-time > start
[DayLightSavingTimeStart]
Defines the date and time when DST begins. This value can be
configured using any of the following formats:
 Day of year - mm:dd:hh:mm, where:

mm denotes month

dd denotes date of the month

hh denotes hour

mm denotes minutes
For example, "05:01:08:00" denotes daylight saving starting from
May 1 at 8 A.M.
 Day of month - mm:day/wk:hh:mm, where:

mm denotes month (e.g., 04)

day denotes day of week (e.g., FRI)

wk denotes week of the month (e.g., 03)

hh denotes hour (e.g., 23)

mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third week of
April, at 11 P.M. The week field can be 1-5, where 5 denotes the
last occurrence of the specified day in the specified month. For
example, "04:FRI/05:23:00" denotes the last Friday of April, at 11
P.M.
End Time / Day of Month
End
configure system > clock >
summer-time > end
[DayLightSavingTimeEnd]
Defines the date and time when DST ends. For a description of the
format of this value, see the DayLightSavingTimeStart parameter.
Offset
configure system > clock >
summer-time > offset
[DayLightSavingTimeOffset]
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For example, if
you configure the parameter at 15:42, the device applies the setting
only at 16:00.
69.3 Debugging and Diagnostics Parameters
This subsection describes the device's debugging and diagnostic parameters.