AudioCodes Mediant 500L - Voice Mail Parameters

User's Manual 1124 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
supp-service dtmf-and-dialing >
special-digits
[IsSpecialDigits]

[0] Disable = Use '*' or '#' to terminate number collection (refer
to the parameter UseDigitForSpecialDTMF). (Default.)
 [1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note:
 The symbols can always be used as the first digit of a dialed
number even if you disable the parameter.
 The parameter is applicable only to analog interfaces.
69.10.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Table 69-41: Voice Mail Parameters
Parameter Description
Voice Mail Interface
configure voip > gateway
voice-mail-setting > vm-
interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines the
communication method between the device and PBX.
 [0] None (default)
 [1] DTMF
 [2] SMDI
 [3] QSIG
 [4] SETUP Only = Applicable only to ISDN.
 [5] MATRA/AASTRA QSIG
 [6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)
 [8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4,
section 9.5.1.1. Enables MWI interworking f
rom IP to Tel, typically
used for BRI phones.
Note: To disable voice mail per Trunk Group, you can use a Tel
Profile with the EnableVoiceMailDelay parameter set to disabled (0).
This eliminates the phenomenon of call delay on Trunks not
implementing voice mail when voice mail is enabled using this global
parameter.
Enable VoiceMail URI
voicemail-uri
[EnableVMURI]
Enables the interworking of target and cause for redirection from Tel
to IP and vice versa, according to RFC 4468.
 [0] Disable (default)
 [1] Enable
Upon receipt of an ISDN Setup message with Redirect values, the
device maps the Redirect phone number to the SIP 'target'
parameter and the Redirect number reason to the SIP 'cause'
parameter in the Request-URI.
Redirecting Reason >> SIP Response Code
Unknown >> 404
User busy >> 486
No reply >> 408
Deflection >> 487/480