AudioCodes Mediant 500L - Automatic Dialing Parameters; Direct Inward Dialing Parameters

User's Manual 1152 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
[CutThrough]
Note:
 The parameter is applicable only to FXS interfaces.
 If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
69.10.5.11 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 69-52: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Automatic Dialing Table
configure voip >
gateway analog
automatic-dialing
[TargetOfChannel]
Defines telephone numbers that are automatically dialed when a specific
FXS or FXO port is off-hooked. The format of the ini file table parameter is
as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
hooked
for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1,10;
Note:
 The first index of this table ini file parameter is 0.
 TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.
 TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.
 This is parameter is applicable only to FXS and FXO interfaces.
 For more information, see 'Configuring Automatic Dialing' on page 615.
69.10.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 69-53: DID Parameters
Parameter Description
DID Wink
configure voip > sip-
definition settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using Wink-Start
signaling, typically used for signaling between an E-911 switch and the
PSAP.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description of the
parameter and for configuring the functionality in the Te
l Profiles table, see
'Configuring Tel Profiles' on page 471.
Note: