Version 7.2 607 Mediant 500L Gateway & E-SBC
User's Manual 27. Configuring Supplementary Services
Parameter Description
midnight (00). This prevents undefined time frames in a day.
Pulse Interval (1 - 4)
pulse-interval-<1-4>
[ChargeCode_PulseInterval<1-4>]
Defines the time interval between pulses (in tenths of a second).
Once the call is established, the device generates a pulse for
each pulse interval.
Pulses On Answer (1 - 4)
pulses-on-answer-<1-4>
[ChargeCode_PulsesOnAnswer<1-
4>]
Defines the number of pulses that the device generates upon
call answer.
27.18 Configuring Voice Mail
The Voice Mail Settings page lets you configure voice mail. For more information on voice
mail, refer to the CPE Configuration Guide for Voice Mail User's Manual. For a detailed
description of the voice mail parameters, see ''Voice Mail Parameters'' on page 1124.
Note: Voice Mail is applicable only to FXO interfaces.
To configure voice mail:
1. Open the Voice Mail Settings page (Setup menu > Signaling & Media tab > Gateway
folder > Voice Mail Settings).
2. Under the General group, configure the following:
• 'Voice Mail Interface' (VoiceMailInterface): Enables the device's Voice Mail
feature and defines the communication method between the device and PBX.
3. Under the Message Waiting Indicator group, configure the digit codes used by the
device for relaying message waiting indication information to the PBX:
To Next Page
Loading...
