AudioCodes Mediant 500L - Multiple Voip Network Interfaces and VLAN Parameters

Version 7.2 1021 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
configure network >
physical-port
[PhysicalPortsTable]
The format of the ini file table parameter is as follows:
[ PhysicalPortsTable ]
FORMAT PhysicalPortsTable_Index = PhysicalPortsTable_Port,
PhysicalPortsTable_Mode, PhysicalPortsTable_SpeedDuplex,
PhysicalPortsTable_PortDescription,
PhysicalPortsTable_GroupMember, PhysicalPortsTable_GroupStatus;
[ \PhysicalPortsTable ]
For more information, see Configuring Physical Ethernet Ports on page
138.
Ethernet Groups Table
Ethernet Groups
configure network > ether-
group
[EtherGroupTable]
Defines the transmit (Tx) and receive (Rx) settings for the Ethernet port
groups. The format of the ini file table parameter is:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For more information, see Configuring Ethernet Port Groups on page
140.
Note: For the parameter to take effect, a device reset is required.
Ethernet Devices table
Ethernet Devices table
configure network >
network-dev
[DeviceTable]
Defines Ethernet Devices (VLANs).
The format of the ini file table parameter is as follows:
[ DeviceTable ]
FORMAT DeviceTable_Index = DeviceTable_VlanID,
DeviceTable_UnderlyingInterface, DeviceTable_DeviceName,
DeviceTable_Tagging; DeviceTable_MTU;
[ \DeviceTable ]
For more information, see Configuring Underlying Ethernet Devices on
page 142.
69.2.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 69-10: IP Network Interfaces and VLAN Parameters
Parameter Description
IP Interfaces Table