Version 7.2 611 Mediant 500L Gateway & E-SBC
User's Manual 28. Analog Gateway
28 Analog Gateway
This section describes configuration of analog settings.
28.1 Configuring Keypad Features
The Keypad Features page lets you configure key sequences that can be pressed on
telephone keypads of FXS endpoints to activate and deactivate the following features:
Call Forward
Caller ID Restriction
Hotline for automatic dialing
Call Waiting
Rejection of Anonymous Calls
Note:
• The Keypad Features page is applicable only to FXS interfaces.
• The method used by the device to collect dialed numbers is identical to the
method used during a regular call (i.e., max digits, interdigit timeout, digit map,
etc.).
• The activation of each feature remains in effect until it is deactivated (i.e., not
deactivated after a call).
• For a description of the keypad parameters, see 'Telephone Keypad Sequence
Parameters' on page 1193.
To configure keypad sequences:
1. Open the Keypad Features page (Setup menu > Signaling & Media tab > Gateway
folder > Analog Gateway > Keypad Features).
Figure 28-1: Configuring Phone Key Sequences to Activate Various Services
To Next Page
Loading...
