AudioCodes Mediant 500L - Channel Parameters; Voice Parameters

User's Manual 1100 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
Tel Profiles Table
Tel Profiles
configure voip > coders-
and-profiles tel-profile
[TelProfile]
Defines the Tel Profile table. Each Tel Profile ID includes a set of
parameters (which are typically configured separately using their
individual, "global" parameters). You can later assign these Tel Profile
IDs to other elements such as in the Trunk Group table (TrunkGroup
parameter). Therefore, Tel Profiles allow you to apply the same settings
of a group of parameters to multiple channels, or apply specific settings
to different channels.
The format of the ini file table parameter is as follows:
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupName,
TelProfile_IsFaxUsed, TelProfile_JitterBufMinDelay,
TelProfile_JitterBufOptFactor, TelProfile_IPDiffServ,
TelProfile_SigIPDiffServ, TelProfile_DtmfVolume, TelProfile_InputGain,
TelProfile_VoiceVolume, TelProfile_EnableReversePolarity,
TelProfile_EnableCurrentDisconnect, TelProfile_EnableDigitDelivery,
TelProfile_EnableEC, TelProfile_MWIAnalog, TelProfile_MWIDisplay,
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia,
TelProfile_ProgressIndicator2IP, TelProfile_TimeForReorderTone,
TelProfile_EnableDIDWink, TelProfile_IsTwoStageDial,
TelProfile_DisconnectOnBusyTone, TelProfile_EnableVoiceMailDelay,
TelProfile_DialPlanIndex, TelProfile_Enable911PSAP,
TelProfile_SwapTelToIpPhoneNumbers, TelProfile_EnableAGC,
TelProfile_ECNlpMode, TelProfile_DigitalCutThrough,
TelProfile_EnableFXODoubleAnswer, TelProfile_CallPriorityMode,
TelProfile_FXORingTimeout, TelProfile_JitterBufMaxDelay,
TelProfile_PlayBusyTone2Isdn;
[\TelProfile]
For a description of the parameter, see Configuring Tel Profiles on page
471.
69.9 Channel Parameters
This subsection describes the device's channel parameters.
69.9.1 Voice Parameters
The voice parameters are described in the table below.
Table 69-34: Voice Parameters
Parameter Description
Input Gain
configure voip > media voice >
input-gain
[InputGain]
Global parameter defining the pulse-code modulation (PCM) input
(received) gain control level (in decibels).
You can also configure the functionality per specific calls, using IP
Profiles (IpProfile_InputGain) or Tel Profiles
(TelProfile_InputGain). For a detailed description of the parameter
and for configuring the functionality, see ''Configuring IP Profiles''
on page 438 or Configuring Tel Profiles on page 471.
Note: If the functionality is configured for a specific profile, the