AudioCodes Mediant 500L - Services; SIP-Based Media Recording Parameters

User's Manual 1244 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
associated with the IP Profile.
Energy Detector Parameters
Enable Energy Detector
configure voip > media ipmedia >
energy-detector-enable
[EnableEnergyDetector]
Enables the Energy Detector feature. This feature generates
events (notifications) when the signal received from the PSTN
is higher or lower than a user-defined threshold (defined by the
EnergyDetectorThreshold parameter).
 [0] Disable (default)
 [1] Enable
Energy Detector Quality Factor
configure voip > media ipmedia >
energy-detector-sensitivity
[EnergyDetectorQualityFactor]
Defines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest sensitivity and
10 the highest sensitivity. The default is 4.
Energy Detector Threshold
configure voip > media ipmedia >
energy-detector-threshold
[EnergyDetectorThreshold]
Defines the Energy Detector's threshold. A signal below or
above this threshold invokes an 'Above' or 'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm + (EnergyDetectorThreshold * 6)
The valid value range is 0 to 7. The default is 3 (i.e., -26 dBm).
69.13 Services
69.13.1 SIP-based Media Recording Parameters
The SIP-based media recording parameters are described in the table below.
Table 69-73: SIP-based Media Recording Parameters
Parameter Description
SIP Recording Application
configure voip > sip-definition
sip-recording settings >
enable-sip-rec
[EnableSIPRec]
Enables the SIP-based Media Recording feature:
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
Recording Server (SRS)
Destination Username
configure voip > sip-definition
sip-recording settings >
siprec-server-dest-username
[SIPRecServerDestUsername]
Defines the SIP user part for the recording server. This user part is
added in the SIP To header of the INVITE message that the device
sends to the recording server.
The valid value is a string of up to 50 characters. By default, no user
part is defined.
SIP Recording Time Stamp
Format
configure voip > sip-
definition sip-
recording settings >
siprec-time-stamp
[SIPRecTimeStamp]
Defines the format of the device's time (timestamp) in SIP messages
that are sent to the SIP Recording Server (SRS).
 [0] Local Time = (Default) The device's local time (without the
UTC time zone) is used for the timestamp.
 [1] UTC = The device's UTC time is used for the timestamp.
Note: The timestamp is contained in the XML body of the SIP
message. If the timestamp uses the UTC time, the time is suffixed
with the letter "Z", for example: