AudioCodes Mediant 500L - SIP Test Call Parameters

Version 7.2 1031 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
The Lifeline (FXS) phone is connected to the following port:
 FXS Port 1
FXS Port 1 connects to the POTS (Lifeline) phone as well as to the
PSTN / PBX, using a splitter cable.
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
 To enable Lifeline upon network failure, the LAN Watchdog
feature must be activated (see the EnableLANWatchDog
parameter).
 The number of supported Lifelines depends on the device’s
hardware configuration. For the combined FXS/FXO configuration,
one Lifeline is available; for the 12-FXS configuration, up to three
Lifelines are available.
 For information on Lifeline cabling, refer to the Installation Manual.
Delay After Reset [sec]
configure voip > sip-definition
advanced-settings > delay-
after-reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by a
DHCP server.
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when the
bit error rate (BER) is greater than 0.001.
 [0] Disable (default)
 [1] Enable
Ignore BRI LOS Alarm
ignore-bri-los-alarm
[IgnoreBRILOSAlarm]
Enables the device to ignore LOS alarms received from the BRI user-
side trunk and attempts to make a call (relevant for IP-to-Tel calls).
 [0] Disable
 [1] Enable (default)
Note: The parameter is applicable only to BRI interfaces.
69.3.2 SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
Table 69-18: SIP Test Call Parameters
Parameter Description
Test Call DTMF String
configure troubleshoot >
test-call settings > testcall-
dtmf-string
[TestCallDtmfString]
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Test Call ID
configure troubleshoot >
test-call settings > testcall-
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is