AudioCodes Mediant 500L - Enabling Syslog; Configuring the Syslog Server Address

User's Manual 964 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Table 60-6: Syslog Message Severity
ITU Perceived Severity
(SNMP Alarm’s Severity)
AudioCodes' Syslog Severity
Critical
RecoverableMsg
Major
RecoverableMsg
Minor
RecoverableMsg
Warning
Notice
Indeterminate
Notice
Cleared
Notice
 Cleared Alarms: CLEAR-ALARM: <Alarm Name>; Textual Description: <Textual
Description>; Severity <Alarm Severity>; Source <Alarm Source>; Unique ID: <Alarm
Unique ID >; If exists Additional Info1:/ Additional Info2:/ Additional Info3:
60.2.2 Enabling Syslog
The following procedure describes how to enable Syslog.
 To enable Syslog:
1. Open the Syslog Settings page (Troubleshoot menu > Troubleshoot tab > Logging
folder > Syslog Settings).
2. From the 'Enable Syslog' drop-down list, select Enable.
Figure 60-2: Enabling Syslog
3. Click Apply.
60.2.3 Configuring the Syslog Server Address
The following procedure describes how to configure the Syslog server's address to where
the device sends Syslog messages.
 To configure the Syslog server address:
1. Open the Syslog Settings page (Troubleshoot menu > Troubleshoot tab > Logging
folder > Syslog Settings).
2. In the 'Syslog Server IP' field (SyslogServerIP), enter the IP address of the Syslog
server.
3. In the 'Syslog Server Port' field, enter the port of the Syslog server.
Figure 60-3: Configuring the Syslog Server Address