AudioCodes Mediant 500L - Call Waiting Parameters

User's Manual 1134 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
[CallerIDTransportType]

[1] Relay = (Currently not applicable.)
 [3] Mute = (Default) The caller ID signal is detected from
the Tel side and then erased from the voice stream.
Note: Caller ID detection is applicable only to FXO
interfaces.
Reject Anonymous Calls Per Port Table
configure voip > gateway analog reject-
anonymous-calls
[RejectAnonymousCallPerPort]
This table parameter determines whether the device rejects
incoming anonymous calls per FXS port. If enabled, when a
device's FXS interface receives an anonymous
call, it rejects
the call and responds with a SIP 433 (Anonymity
Disallowed) response.
The format of the ini file table parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable,
RejectAnonymousCallPerPort_Port,
RejectAnonymousCallPerPort_Module;
[\RejectAnonymousCallPerPort]
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
 Port = Port number.
 Module = Module number.
For example:
RejectAnonymousCallPerPort 0 = 0,1,1;
RejectAnonymousCallPerPort 1 = 1,2,1;
Note: The parameter is applicable only to FXS interfaces.
69.10.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 69-43: Call Waiting Parameters
Parameter Description
Enable Call Waiting
configure voip > gateway dtmf-
supp-service supp-service-
settings > call-waiting
[EnableCallWaiting]
Enables the Call Waiting feature.
 [0] Disable
 [1] Enable (Default)
For digital interfaces: If enabled and the device initiates a Tel-to-
IP
call to a destination that is busy, it plays a call waiting ringback
tone to the caller. The tone is played only if the destination returns
a 182 "Queued" SIP response.
For FXS interface: If enabled, when an FXS interface receives a
call on a busy endpoint, it responds with a 182 response (and not
with a 486 busy). The device plays a call waiting indication signal.
When hook-flash is detected, the device switches to the waiting
call. The device that initiated the waiting call plays a call waiting
ringback tone to the calling party after a 182 response is received.
Note: