User's Manual 1154 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
69.10.5.13 ISDN BRI Parameters
The ISDN BRI call forwarding service parameters are described in the table below.
Table 69-54: BRI Call Forwarding Services Parameters
Parameter Description
BRI-to-SIP Supplementary Services Codes for Call Forward
For more information, see ''BRI Call Forwarding'' on page 578.
Call Forward Unconditional
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-code
[SuppServCodeCFU]
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward Unconditional
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-
deactivation-code
[SuppServCodeCFUDeact]
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-code
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy sent to the
softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-
deactivation-code
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-code
[SuppServCodeCFNR]
Defines the prefix code for activating Call Forward on No Reply sent to
the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-
deactivation-code
[SuppServCodeCFNRDeact]
Defines the prefix code for deactivating Call Forward on No Reply
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
To Next Page
Loading...
