User's Manual 1144 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
Supplementary Services
Table
configure voip >
gateway digital isdn-
supp-serv
[ISDNSuppServ]
Defines phone extension numbers per FXS/BRI port and configures
various supplementary services per endpoint.
The format of the ini file table parameter is as follows:
[ ISDNSuppServ ]
FORMAT ISDNSuppServ_Index = ISDNSuppServ_PhoneNumber,
ISDNSuppServ_LocalPhoneNumber, ISDNSuppServ_Module,
ISDNSuppServ_Port, ISDNSuppServ_UserId,
ISDNSuppServ_UserPassword, ISDNSuppServ_CallerID,
ISDNSuppServ_IsPresentationRestricted,
ISDNSuppServ_IsCallerIDEnabled, ISDNSuppServ_CFB2PhoneNumber,
ISDNSuppServ_CFNR2PhoneNumber,
ISDNSuppServ_CFU2PhoneNumber, ISDNSuppServ_NoReplyTime;
[ \ISDNSuppServ ]
For more information, see ''Configuring Multi-Line Extensions and
Supplementary Services'' on page 599.
69.10.5.8 Three-Way Conferencing Parameters
The three-way conferencing parameters are described in the table below.
Table 69-49: Three-Way Conferencing Parameters
Parameter Description
Enable 3-Way Conference
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-3w-conf
[Enable3WayConference]
Enables the 3-Way Conference feature.
[0] Disable (default)
[1] Enable
Note: For the parameter to take effect, a device reset is required.
3-Way Conference Mode
configure voip > gateway dtmf-
supp-service supp-service-
settings > 3w-conf-mode
[3WayConferenceMode]
Defines the mode of operation for three-way conferencing.
[0] AudioCodes Media Server = (Default) The conference-
initiating INVITE sent by the device, uses the ConferenceID
concatenated with a unique identifier as the Request-URI. This
same Request-URI is set as the Refer-To header value in the
REFER messages that are sent to the two remote parties. This
conference mode is used when operating with AudioCodes
IPMedia conferencing server.
[1] Non-AudioCodes Media Server = The conference-initiating
INVITE sent by the device, uses only the ConferenceID as the
Request-URI. The Conference server sets the Contact header of
the 200 OK response to the actual unique identifier (Conference
URI) to be used by the participants. This Conference URI is then
included by the device in the Refer-To header value in the
REFER messages sent by the device to the remote parties. The
remote parties join the conference by sending INVITE messages
to the conference using this conference URI.
[2] On Board = On-board, three-way conference. The
conference is established on the device without the need of an
external Conference server. You can limit the number of
simultaneous, on-board 3-way conference calls, by using the
MaxInBoardConferenceCalls parameter.
[3] Huawei Media Server = The conference is managed by an
To Next Page
Loading...
