AudioCodes Mediant 500L - Enabling SIP-Based Media Recording

Version 7.2 235 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
aUCID>
</session>
<participant id="1056" session="0000-0000-0000-0000-
00000000d0d71a52">
<nameID aor="1056@192.168.241.20"></nameID>
<associate-time>2010-01-24T01:11:57Z</associate-time>
<send>00000000-0000-0000-0000-1CF23A36C4E3</send>
<recv>00000000-0000-0000-0000-BF583A36C4E3</recv>
</participant>
<participant id="182052092" session="0000-0000-0000-0000-
00000000d0d71a52">
<nameID aor="182052092@voicelab.local"></nameID>
<associate-time>2010-01-24T01:11:57Z</associate-time>
<recv>00000000-0000-0000-0000-1CF23A36C4E3</recv>
<send>00000000-0000-0000-0000-BF583A36C4E3</send>
</participant>
<stream id="00000000-0000-0000-0000-1CF23A36C4E3" session="0000-
0000-0000-0000-00000000d0d71a52">
<label>1</label>
</stream>
<stream id="00000000-0000-0000-0000-BF583A36C4E3" session="0000-
0000-0000-0000-00000000d0d71a52">
<label>2</label>
</stream>
</recording>
--boundary_ac1fffff85b—
15.2.1 Enabling SIP-based Media Recording
The following procedure describes how to enable the SIP-based media Recording feature.
 To enable SIP-based media recording:
1. Open the SIP Recording Settings page (Setup menu > Signaling & Media tab > SIP
Recording folder > SIP Recording Settings).
Figure 15-7: Enabling SIPRec
2. From the 'SIP Recording Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Note: SIPRec is a license-dependant feature and is available only if it is included in
the License Key installed on the device. For more information, see SIP-based Media
Recording on page 229.