AudioCodes Mediant 500L - Routing Parameters

User's Manual 1022 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
IP Interfaces
configure network > interface
network-if
[InterfaceTable]
The table configures IP network interfaces.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes, InterfaceTable_InterfaceMode,
InterfaceTable_IPAddress, InterfaceTable_PrefixLength,
InterfaceTable_Gateway, InterfaceTable_VlanID,
InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For more information, see ''Configuring IP Network Interfaces'' on
page 145.
[EnableNTPasOAM] Defines the application type for Network Time Protocol (NTP)
services.
 [1] = OAMP (default)
 [0] = Control
Note: For the parameter to take effect, a device reset is required.
69.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 69-11: IP Network Routing Parameters
Parameter Description
Send ICMP Unreachable
Messages
configure network >
network-settings > icmp-
disable-unreachable
[DisableICMPUnreachable]
Enables sending of ICMP Unreachable messages.
 [0] Enable = (Default) Device sends these messages.
 [1] Disable = Device does not send these messages.
Send and Receive ICMP
Redirect Messages
configure network >
network-settings > icmp-
disable-redirec
[DisableICMPRedirects]
Enables sending and receiving of ICMP Redirect messages.
 [0] Enable = (Default) Device sends and accepts these messages.
 [1] Disable = Device rejects these messages and also does not send
them.
Static Routes Table
Static Routes
configure network > static
[StaticRouteTable]
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]