AudioCodes Mediant 500L - Configuring DTMF Tones for Test Calls

User's Manual 990 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Statistics Field Description
 Number of currently active test calls.

Number of successfully answered calls out of the total number of
calls attempted (Answer Success Ratio or ASR).
 "Receiving (<number of active calls>)": Test call has been
automatically activated by calls received for this configured test call
endpoint from the configured remote endpoint. When all these calls
terminate, the status returns to "Idle".
 "Terminating (<number of active calls>)": The Drop Call command
has been clicked to stop the test call and the test call is in the
process of terminating the currently active test calls.
 "Done - Established Calls: <number of established calls>, ASR:
<ASR>%": Test call has been successfully completed (or was
prematurely stopped by clicking the Drop Call command) and shows
the following:

Total number of test calls that were established.

Number of successfully answered calls out of the total number of
calls attempted (ASR).
MOS Status
MOS count and color threshold status of local and remote sides
according to the assigned QoE Profile.
Delay Status
Packet delay count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Jitter Status
Jitter count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Packet Loss Status
Packet loss count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Bandwidth Status
Tx/Rx bandwidth and color-threshold status according to the assigned
Bandwidth Profile.
66.5 Configuring DTMF Tones for Test Calls
By default, the device plays the DTMF signal tone "3212333" to remote tested endpoints
for answered calls (incoming and outgoing). For basic test calls (as described in
Configuring Basic Test Calls on page 991), the device can play only the configured DTMF
tones (or none, if not configured). For test call endpoints that are configured in the Test Call
Rules table, you can configure the device to play either DTMF tones or a tone from an
installed PRT file (Test Call Tone). For more information, see Configuring Test Call
Endpoints on page 983.
Note:
• You can configure the DTMF signaling type (e.g., out-of-band or in-band) using
the 'DTMF Transport Type' parameter. For more information, see ''Configuring
DTMF Transport Types'' on page 201.
• To generate DTMF tones, the device's DSP resources are required.
 To configure played DTMF signal to answered test call:
1. Open the Test Call Settings page (Troubleshooting tab > Troubleshooting menu >
Test Call folder > Test Call Settings).