AudioCodes Mediant 500L - Configuring SBC User Info Table through CLI; Configuring SBC User Info Table in Loadable Text File

User's Manual 814 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
45.6.3.2 Configuring SBC User Info Table through CLI
The SBC User Info table can be configured in the CLI using the following commands:
 To add and/or modify a user (example):
# configure voip
(config-voip)# sip-definition proxy-and-registration
(sip-def-proxy-and-reg)# user-info sbc-user-info <index, e.g.,
1>
(sbc-user-info-1)# username JohnDee
(sbc-user-info-1)# <activate | exit>
 To delete a specific user, use the no command:
(sip-def-proxy-and-reg)# no user-info sbc-user-info <index,
e.g., 1>
 To view all table entries:
(sip-def-proxy-and-reg)# user-info sbc-user-info display
---- sbc-user-info-0 ----
local-user (JohnDee)
username (userJohn)
password (s3fn+fn=)
ip-group-id (1)
status (not-resgistered)
---- sbc-user-info-1 ----
local-user (SuePark)
username (userSue)
password (t6sn+un=)
ip-group-id (1)
status (not-resgistered)
 To view a specific entry (example):
(sip-def-proxy-and-reg)# user-info sbc-user-info <index, e.g.,
0>
(sbc-user-info-0)# display
local-user (JohnDee)
username (userJohn)
password (s3fn+fn=)
ip-group-id (1)
status (not-resgistered)
 To search a user by local-user:
(sip-def-proxy-and-reg)# user-info find <local-user, e.g.,
JohnDoe>
JohnDee: Found at index 0 in SBC user info table, not
registered
Note: To configure the User Info table, make sure that you have enabled the feature
as described in ''Enabling the User Info Table'' on page 807.
45.6.3.3 Configuring SBC User Info Table in Loadable Text File
The SBC User Info table can be configured as a User Info file using a text-based file (*.txt).
This file can be created using any text-based program such as Notepad. This User Info file
is the same file used for the GW User Info table. Thus, this file can include both Gateway
and SBC user information.