User's Manual 294 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
http://<device's WAN IP address:port>/url prefix/
b. Define the IP address of the managed equipment (see ''Configuring HTTP
Proxy Hosts'' on page 298).
Note:
For this feature, no special configuration is required on the managed
equipment.
HTTP-based OVOC Services for AudioCodes Equipment behind NAT:
You can configure the device to act as an HTTP Proxy that enables AudioCodes
OVOC to manage AudioCodes equipment (such as IP Phones) over HTTP when the
equipment is located behind NAT (e.g., in the LAN) and OVOC is located in a public
domain (e.g., in the WAN). Thus, the feature resolves NAT traversal issues. The IP
Phones register with the device in order to allow communication between the IP
Phones and the OVOC.
To support the functionality, the following configuration is required:
1. Enable the HTTP Proxy application (see ''Enabling the HTTP Proxy Application''
on page 294).
2. Configure two local, listening HTTP interfaces - one for the OVOC and one for the
IP Phones (see ''Configuring HTTP Interfaces'' on page 295).
3. Configure the address of the OVOC server (see ''Configuring an HTTP-based
OVOC Service'' on page 300).
15.7.1 Enabling the HTTP Proxy Application
Before you can configure HTTP-based proxy services, you must enable the HTTP Proxy
application, as described in the following procedure. Once enabled, the Web interface
displays menus in the Navigation pane that are relevant to the HTTP Proxy application.
Note: The HTTP Proxy application is a license-dependent feature and is available
only if it is included in the License Key installed on the device. For ordering the
feature, please contact your AudioCodes sales representative. For installing a new
License Key, see License Key on page 817.
To enable the HTTP Proxy application:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder
> General Settings).
Figure 15-51: Enabling HTTP Proxy Application
2. From the 'HTTP Proxy Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
To Next Page
Loading...
