Version 7.2 961 Mediant 500L Gateway & E-SBC
User's Manual 60. Syslog and Debug Recording
Message Item Description
[BID=<last 6 characters in MAC>:<number of times device has
reset>]
For example:
14:32:52.062: 10.33.8.70: WARNING: [S=9399]
[BID=2ed1c8:96] invalid Physical index
Where:
2ed1c8 is the device's MAC address.
96 is the number of times the device has reset.
Message Body
Describes the message.
Timestamp
When the Network Time Protocol (NTP) is enabled, a timestamp
string [hour:minutes:seconds] is added to all Syslog messages.
60.2.1.1 Event Representation in Syslog Messages
The Syslog message events that the device sends are denoted by unique abbreviations.
The following example shows an abbreviated event in a Syslog message indicating packet
loss (PL):
Apr 4 12:00:12 172.30.1.14 PL:5 [Code:3a002] [CID:3294] [Time:
20:17:00]
The table below lists the unique event abbreviations:
Table 60-4: Syslog Error Name Descriptions
Error Abbreviation Error Name Description
AA
Invalid Accumulated Packets Counter
AC
Invalid Channel ID
AL
Invalid Header Length
AO
Invalid Codec Type
AP
Unknown Aggregation Payload Type
AR
Invalid Routing Flag Received
AT
Simple Aggregation Packets Lost
CC
Command Checksum Error
CE
Invalid Cell Coder Code
CS
Command Sequence Error
ES
8 sec Timeout Before Disconnect
HO
Host Received Overrun
IA
Invalid AMR Payload
IC
Invalid CID Error
IG
Invalid G723 Code
IP
Invalid payload length
IR
Invalid RTCP Packet
To Next Page
Loading...
