AudioCodes Mediant 500L - Ini File Parameters; SNMP Parameters

User's Manual 1010 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
and configure a different number of output lines, by using the
window-height CLI command in the currently active CLI session.
69.1.4 ini File Parameters
The parameters relating to ini-file management are described in the table below.
Table 69-4: ini File Parameters
Parameter Description
[INIPasswordsDisplayType]
Defines how passwords are displayed in the ini file.
 [0] = (default) Disable. Passwords are obscured ("encoded"). The
passwords are displayed in the following syntax: $1$<obscured
password> (e.g., $1$S3p+fno=).

[1] = Enable. All passwords are hidden and replaced by an asterisk
(*).
69.1.5 SNMP Parameters
The SNMP parameters are described in the table below.
Table 69-5: SNMP Parameters
Parameter Description
Disable SNMP
configure system > snmp settings >
disable
[DisableSNMP]
Enables and disables SNMP.
 [0] No = (Default) SNMP is enabled.
 [1] Yes = SNMP is disabled.
configure system > snmp settings >
port
[SNMPPort]
Defines the device's local (LAN) UDP port used for SNMP
Get/Set commands.
The range is 100 to 3999. The default port is 161.
Note: For the parameter to take effect, a device reset is
required.
[ChassisPhysicalAlias] Defines the 'alias' name object for the physical entity as
specified by a network manager, and provides a non-volatile
'handle' for the physical entity.
The valid range is a string of up to 255 characters.
[ChassisPhysicalAssetID] Defines the user-assigned asset tracking identifier object for
the device's chassis as specified by OVOC, and provides
non-volatile storage of this information.
The valid range is a string of up to 255 characters.
[ifAlias] Defines the textual name of the interface. The value is equal
to the ifAlias SNMP MIB object.
The valid range is a string of up to 64 characters.
configure system > snmp trap > auto-
send-keep-alive
[SendKeepAliveTrap]
Enables the device to send NAT keep-alive traps to the port
of the SNMP network management station (e.g., AudioCodes
OVOC). This is used for NAT traversal, and allows SNMP
communication with AudioCodes OVOC management