AudioCodes Mediant 500L - Page 1011

Version 7.2 1011 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
platform, located in the WAN, when the device is located
behind NAT. It is needed to keep the NAT pinhole open for
the SNMP messages sent from OVOC to the device. The
device sends the trap periodically - every 9/10 of the time
configured by the NATBindingDefaultTimeout parameter. The
trap that is sent is acKeepAlive. For more information on the
SNMP trap, refer to the SNMP Reference Guide.
 [0] = (Default) Disable
 [1] = Enable
To configure the port number, use the KeepAliveTrapPort
parameter.
Note: For the parameter to take effect, a device reset is
required.
[KeepAliveTrapPort] Defines the port of the SNMP network management station to
which the device sends keep-alive traps.
The valid range is 0 - 65534. The default is port 1161.
To enable NAT keep-alive traps, use the SendKeepAliveTrap
parameter.
[PM_EnableThresholdAlarms] Enables the sending of the SNMP trap event,
acPerformanceMonitoringThresholdCrossing which is sent
every time the threshold (high and low) of a Performance
Monitored object (e.g.,
acPMMediaRealmAttributesMediaRealmBytesTxHighThresho
ld) is crossed.
 [0] = (Default) Disable
 [1] = Enable
configure system > snmp settings >
sys-oid
[SNMPSysOid]
Defines the SNMP MIB OID for the base product system.
The default is 1.3.6.1.4.1.5003.8.1.1.
Note:
 For the parameter to take effect, a device reset is required.
 The device automatically adds the device’s unique product
identifier number at the end of your OID.
[SNMPTrapEnterpriseOid] Defines the SNMP MIB OID for the Trap Enterprise.
The default is 1.3.6.1.4.1.5003.9.10.1.21.
Note:
 For the parameter to take effect, a device reset is required.
 The device automatically adds the device’s unique product
identifier number at the end of your OID.
[acUserInputAlarmDescription] Defines the description of the input alarm.
[acUserInputAlarmSeverity] Defines the severity of the input alarm.
[ActiveAlarmTableMaxSize] Defines the maximum number of currently active alarms that
can be displayed in the Active Alarms table. When the table
reaches this user-defined maximum capacity (i.e., full), the
device sends the SNMP trap event,
acActiveAlarmTableOverflow. If the table is full and a new
alarm is raised by the <device>, the new alarm is not
displayed in the table.