Version 7.2 295 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
15.7.2 Debugging Remote HTTP Services
You can enable the device to generate debug messages for remote Web (HTTP) services
and send them to a Syslog server.
To enable debugging of HTTP services:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder
> General Settings):
2. From the 'HTTP Proxy Debug Level' drop-down list, select one of the following:
• No Debug: Disables debugging.
• Basic: Enables debugging and sends basic information in the Syslog.
• Detailed: Enables debugging and sends detailed information in the Syslog.
3. Click Apply.
15.7.3 Configuring HTTP Interfaces
The HTTP Interfaces table lets you configure up to 10 HTTP Interfaces. An HTTP Interface
represents a local, listening interface for receiving HTTP/S requests from HTTP-based
(Web) clients such as managed equipment (e.g., IP Phones) and/or AudioCodes OVOC
management tool for HTTP/S-based services.
The following procedure describes how to configure HTTP Interfaces through the Web
interface. You can also configure it through ini file (HTTPInterface) or CLI (configure
network > http-proxy http-interface).
To configure an HTTP Interface:
1. Open the HTTP Interfaces table (Setup menu > IP Network tab > HTTP Proxy folder
> HTTP Interfaces).
2. Click New; the following dialog box appears:
Figure 15-52: HTTP Interfaces Table - Add Dialog Box
3. Configure an HTTP Interface according to the parameters described in the table
below.
To Next Page
Loading...
