AudioCodes Mediant 500L - Telephone Keypad Sequence Parameters

Version 7.2 1193 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Note:
 To associate a configured Charge Code to an outgoing Tel-to-IP call,
use the Tel-to-IP Routing table.
 To configure the Charge Codes table using the Web interface, see
Configuring Charge Codes Table on page 605.
69.10.10 Telephone Keypad Sequence Parameters
The telephony keypad sequence parameters are described in the table below.
Table 69-64: Telephone Keypad Sequence Parameters
Parameter Description
Call Pickup Key
configure voip > sip-definition
settings > call-pickup-key
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call
pick-up allows the FXS endpoint to answer another telephone's
incoming call by pressing this user-defined sequence of digits.
When the user dials these digits (e.g., #77), the incoming call from
another phone is forwarded to the user's phone.
The valid value is a string of up to 15 characters (0-
9, #, and *). By
default, no value is defined.
Note:
 Call pick-up is configured only for FXS endpoints pertaining to
the same Trunk Group.
 The parameter is applicable only to FXS interfaces.
Prefix for External Line
[Prefix2ExtLine] Defines a string prefix (e.g., '9' dialed for an external line) that
when dialed, the device plays a secondary dial tone (i.e., stutter
tone) to the FXS line and then starts collecting the subsequently
dialed digits from the FXS line.
The valid range is a one-character string. By default, no value is
defined.
Note:

You can enable the device to add this string as the prefix to the
collected (and sent) digits, using the parameter
AddPrefix2ExtLine.
 The parameter is applicable only to FXS interfaces.
configure voip > gateway
manipulation settings > prefix-2-
ext-line
[AddPrefix2ExtLine]
Enables the device to add the prefix string for accessing an
external line (configured by the Prefix2ExtLine parameter) to the
dialed (called) number as the prefix, which is sent to the IP
destination (for Tel-to-IP calls).