AudioCodes Mediant 500L - IP Connectivity Parameters

Version 7.2 1209 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
[ \GwRoutingPolicy ]
For more information, see ''Configuring a Gateway Routing
Policy Rule'' on page 523.
69.10.13 IP Connectivity Parameters
The IP connectivity parameters are described in the table below.
Table 69-67: IP Connectivity Parameters
Parameter Description
Enable Alt Routing Tel to IP
configure voip > gateway routing
settings > alt-routing-tel2ip
[AltRoutingTel2IPEnable]
Enables the Alternative Routing feature for Tel-to-IP calls.
 [0] Disable = (Default) Disables the Alternative Routing
feature.
 [1] Enable = Enables the Alternative Routing feature.
 [2] Status Only = The Alternative Routing feature is disabled,
but read-only information on the QoS of the destination IP
addresses is provided.
Note: If the parameter is enabled, the Busy Out feature (see
EnableBusyOut parameter) does not function with the Proxy Set
keep-alive mechanism. To use the Busy Out feature with the
Proxy Set keep-alive mechanism (for IP Groups), disable the
parameter.
Alt Routing Tel to IP Mode
configure voip > gateway routing
settings > alt-rte-tel2ip-mode
[AltRoutingTel2IPMode]
Determines the IP Connectivity event(s) reason for triggering
Alternative Routing.
 [0] None = Alternative routing is not used.
 [1] Connectivity = Alternative routing is performed if SIP
OPTIONS message to the initial destination fails (determined
according to the AltRoutingTel2IPConnMethod parameter).
 [2] QoS = Alternative routing is performed if poor QoS is
detected.
 [3] Both = (Default) Alternative routing is performed if either
SIP OPTIONS to initial destination fails, poor QoS is detected,
or the DNS host name is not resolved.
Note:
 QoS is quantified according to delay and packet loss
calculated according to previous calls. QoS statistics are reset
if no new data is received within two minutes.
 To receive quality information (displayed in the 'Quality Status'
and 'Quality Info.' fields in ''Viewing IP Connectivity'' on page
900) per destination, the parameter must be set to 2 or 3.