User's Manual 786 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
43.5 Disconnecting Active Calls
You can forcibly disconnect all active calls, or disconnect specific calls based on Session
ID.
To disconnect calls through CLI:
Disconnect all active calls:
# clear voip calls
Disconnect active calls belonging to a specified Session ID:
# clear voip calls <Session ID>
43.6 Configuring Name for Telephony Ports
You can configure an arbitrary name or a brief description for each telephony port
displayed on the Home page. This description is displayed as a tooltip when you hover
your mouse over the port.
Note: Only alphanumerical characters can be used in the port description.
To add a port description:
1. Open the Monitor home page (see 'Viewing Device Status on Monitor Page' on page
870).
2. Click the required port icon; a shortcut menu appears:
3. From the shortcut menu, choose Port Description; the following dialog box appears:
Figure 43-2: Configuring Analog Port Description
4. Type a brief description for the port, and then click Submit.
To Next Page
Loading...
