AudioCodes Mediant 500L - Control Network Parameters; IP Group, Proxy, Registration and Authentication Parameters

User's Manual 1052 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
For more information, see ''Configuring Performance Profiles'' on page
889.
69.6 Control Network Parameters
69.6.1 IP Group, Proxy, Registration and Authentication Parameters
The proxy server, registration and authentication SIP parameters are described in the table
below.
Table 69-30: Proxy, Registration and Authentication SIP Parameters
Parameter Description
IP Groups Table
IP Groups
configure voip > ip-group
[IPGroup]
This table configures IP Groups.
The format of the ini file table parameter is:
[ IPGroup ]
FORMAT IPGroup_Index = IPGroup_Type, IPGroup_Name,
IPGroup_ProxySetName, IPGroup_SIPGroupName,
IPGroup_ContactUser, IPGroup_SipReRoutingMode,
IPGroup_AlwaysUseRouteTable, IPGroup_SRDName,
IPGroup_MediaRealm, IPGroup_ClassifyByProxySet,
IPGroup_ProfileName, IPGroup_MaxNumOfRegUsers,
IPGroup_InboundManSet, IPGroup_OutboundManSet,
IPGroup_RegistrationMode, IPGroup_AuthenticationMode,
IPGroup_MethodList, IPGroup_EnableSBCClientForking,
IPGroup_SourceUriInput, IPGroup_DestUriInput,
IPGroup_ContactName, IPGroup_Username,
IPGroup_Password, IPGroup_UUIFormat, IPGroup_QOEProfile,
IPGroup_BWProfile, IPGroup_AlwaysUseSourceAddr,
IPGroup_MsgManUserDef1, IPGroup_MsgManUserDef2,
IPGroup_SIPConnect, IPGroup_SBCPSAPMode,
IPGroup_DTLSContext, IPGroup_CreatedByRoutingServer,
IPGroup_UsedByRoutingServer, IPGroup_SBCOperationMode,
IPGroup_SBCRouteUsingRequestURIPort,
IPGroup_SBCKeepOriginalCallID, IPGroup_TopologyLocation,
IPGroup_SBCDialPlanName, IPGroup_CallSetupRulesSetId,
IPGroup_Tags, IPGroup_SBCUserStickiness,
IPGroup_UserUDPPortAssignment;
[/IPGroup]
For more information, see ''Configuring IP Groups'' on page 363.
Note: For the parameter to take effect, a device reset is
required.
Authentication per Port Table
Authentication
configure voip > gateway analog
authentication
[Authentication]
The table defines a user name and password for authenticating
each device port. The format of the ini file table parameter is as
follows:
[Authentication]
FORMAT Authentication_Index = Authentication_UserId,
Authentication_UserPassword, Authentication_Module,