AudioCodes Mediant 500L - Digit Collection and Dial Plan Parameters

User's Manual 1122 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
disconnect).
For more information, see Interworking Keypad DTMFs for
SIP-to-ISDN Calls on page 566.
Note:
 This feature is not applicable to re-INVITE messages.
69.10.3 Digit Collection and Dial Plan Parameters
The digit collection and dial plan parameters are described in the table below.
Table 69-40: Digit Collection and Dial Plan Parameters
Parameter Description
Dial Plan Index
configure voip > gateway dtmf-
supp-service dtmf-and-dialing >
dial-plan-index
[DialPlanIndex]
Defines the Dial Plan index to use in the external Dial Plan file. The
Dial Plan file is loaded to the device as a .dat file (converted using
the DConvert utility). The Dial Plan index can be defined globally or
per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1 denotes
PLAN2, and so on. The default is -
1, indicating that no Dial Plan file
is used.
Note:
 If the parameter is configured to select a Dial Plan index, the
settings of the parameter DigitMapping are ignored.
 If the parameter i
s configured to select a Dial Plan index from an
external Dial Plan file, the device first attempts to locate a
matching digit pattern in the Dial Plan file, and if not found, then
attempts to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.
 The parameter is also applicable to ISDN with overlap dialing.
 The parameter can also be configured in a Tel Profile.
 For more information on the Dial Plan file, see ''Dialing Plans for
Digit Collection'' on page 800.
configure voip > gateway
manipulation settings > tel2ip-
src-nb-map-dial-index
[Tel2IPSourceNumberMapping
DialPlanIndex]
Defines the Dial Plan index in the external Dial Plan file for the Tel-
to-IP Source Number Mapping feature.
The valid value range is 0 to 7, defining the Dial Plan index [Plan x]
in the Dial Plan file. The default is -1 (disabled).
For more information on this feature, see ''Modifying ISDN-to-IP
Calling Party Number using Dial Plan File'' on page 805.
Digit Mapping Rules
configure voip > gateway dtmf-
supp-service dtmf-and-dialing >
digitmapping
[DigitMapping]
Defines the digit map pattern (used to reduce the dialing period
when ISDN overlap dialing). If the digit string (i.e., dialed number)
matches one of the patterns in the digit map, the device stops
collecting digits and establishes a call with the collected number.
The digit map pattern can contain up to 52 options (rules), each
separated by a vertical bar (|). The maximum length of the entire
digit pattern is 152 characters. The available notations include the
following:
 [n-m]: Range of numbers (not letters).
 . (single dot): Repeat digits until next notation (e.g., T).
 x: Any single digit.