AudioCodes Mediant 500L - Assigning Cost Groups to Routing Rules

Version 7.2 281 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
5. Click Apply, and then save your settings to flash memory.
Table 15-18: Time Band Table Description
Parameter Description
Index
timeband-index
[CostGroupTimebands_TimebandIndex]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Start Time
start-time
[CostGroupTimebands_StartTime]
Defines the day and time of day from when this time band
is applicable. The format is DDD:hh:mm, where:
 DDD is the day of the week, represented by the first
three letters of the day in upper case (i.e., SUN, MON,
TUE, WED, THU, FRI, or SAT).
 hh and mm denote the time of day, where hh is the
hour (00-23) and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
End Time
end-time
[CostGroupTimebands_EndTime]
Defines the day and time of day until when this time band
is applicable. For a description of the valid values, see the
parameter above.
Connection Cost
connection-cost
[CostGroupTimebands_ConnectionCost]
Defines the call connection cost during the time band. This
is added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not
a decimal).
Minute Cost
minute-cost
[CostGroupTimebands_MinuteCost]
Defines the call cost per minute charge during the time
band.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not
a decimal).
15.5.2.2 Assigning Cost Groups to Routing Rules
To use your configured Cost Groups, you need to assign them to routing rules:

Gateway application: Tel-to-IP Routing table - see Configuring Tel-to-IP Routing Rules
on page
509

SBC application: IP-to-IP Routing table - see Configuring SBC IP-to-IP Routing Rules
on page
685