User's Manual 300 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
TLS Context
tls-context
[HTTPProxyHost_TLSContext]
Assigns a TLS Context for the TLS connection with the HTTP
Proxy host.
By default, the default TLS Context (Index 0) is assigned.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 113.
Note: The parameter is applicable only if the connection
protocol is HTTPS (defined using the 'Protocol' parameter,
above).
Verify Certificate
verify-cert
[HTTPProxyHost_VerifyCert]
Enables TLS certificate verification when the connection with
the host is based on HTTPS.
[0] No = No certificate verification is done.
[1] Yes = (Default) The device verifies the authentication of
the certificate received from the HTTPS peer. The device
authenticates the certificate against the trusted root
certificate store associated with the associated TLS Context
(see 'TLS Context' parameter above) and if ok, allows
communication with the HTTPS peer. If authentication fails,
t
he device denies communication (i.e., handshake fails). The
device can also authenticate the certificate by querying with
an Online Certificate Status Protocol (OCSP) server whether
the certificate has been revoked. This is also configured for
the associated TLS Context.
Note: The parameter is applicable only if the connection
protocol is HTTPS (defined using the 'Protocol' parameter,
above).
15.7.5 Configuring an HTTP-based OVOC Service
The OVOC Services table lets you configure a single HTTP-based OVOC service. For
more information on the OVOC service, see ''HTTP-based Proxy Services'' on page 293.
The following procedure describes how to configure an OVOC Service through the Web
interface. You can also configure it through ini file (EMSService) or CLI (configure network
> http-proxy ems-serv).
To configure an OVOC Service:
1. Open the OVOC Services table (Setup menu > IP Network tab > HTTP Proxy folder
> OVOC Services).
To Next Page
Loading...
