AudioCodes Mediant 500L - Page 299

Version 7.2 299 Mediant 500L Gateway & E-SBC
User's Manual 15. Services
3. Click New; the following dialog box appears:
Figure 15-54: HTTP Proxy Hosts Table - Add Dialog Box
4. Configure an HTTP Proxy Host according to the parameters described in the table
below.
5. Click Apply, and then save your settings to flash memory.
Table 15-23: HTTP Proxy Hosts Table Parameter Descriptions
Parameter Description
General
Index Defines an index number for the new table row.
Note:
 Each row must be configured with a unique index.
 The parameter is mandatory.
Network Interface
network-interface
[HTTPProxyHost_NetworkInterface]
Assigns a local, network interface to the HTTP Proxy Host.
By default, no value is defined.
To configure network interfaces, see ''Configuring IP Network
Interfaces'' on page 145.
Note: The parameter is mandatory.
Proxy Address
proxy-address
[HTTPProxyHost_IpAddress]
Defines the address of the managed equipment (host).
The valid value is an IP address in dotted-decimal notation or
an FQDN (up to 100 characters). If the address is an FQDN,
the device uses DNS to resolve it into an IP address. If the DNS
resolution results in multiple IP addresses, the device uses the
first available address (i.e., that responds to the keep-alive).
Protocol
protocol
[HTTPProxyHost_Protocol]
Defines the protocol type.
 [0] HTTP (default)
 [1] HTTPS
HTTP Port
http-port
[HTTPProxyHost_Port]
Defines the port of the managed equipment.
The default is 0.
Note: The parameter is mandatory.
Security