AudioCodes Mediant 500L - Web Parameters

User's Manual 1004 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of the parameter, see ''Configuring Web and
Telnet Access List'' on page 83.
Local Users Table
Local Users
configure system >
user
[WebUsers]
The table defines management users.
The format of the ini file table parameter is as follows:
[ WebUsers ]
FORMAT WebUsers_Index = WebUsers_Username,
WebUsers_Password, WebUsers_Status,
WebUsers_PwAgeInterval, WebUsers_SessionLimit,
WebUsers_CliSessionLimit, WebUsers_SessionTimeout,
WebUsers_BlockTime, WebUsers_UserLevel,
WebUsers_PwNonce, WebUsers_SSHPublicKey;
[ \WebUsers ]
For more information, see Configuring Management User Accounts
on page 73.
Additional Management Interfaces Table
Additional Management
Interfaces
configure system >
additional-mgmt-if
[AdditionalManagementInterf
aces]
The table defines additional management interfaces.
The format of the ini file table parameter is as follows:
[ AdditionalManagementInterfaces ]
FORMAT AdditionalManagementInterfaces_Index =
AdditionalManagementInterfaces_InterfaceName,
AdditionalManagementInterfaces_TLSContextName,
AdditionalManagementInterfaces_HTTPSOnly;
[ \AdditionalManagementInterfaces ]
For more information, see Configuring Additional Management
Interfaces on page 72.
69.1.2 Web Parameters
The Web parameters are described in the table below.
Table 69-2: Web Parameters
Parameter Description
Enable web access from all
interfaces
web-access-from-all-interfaces
[EnableWebAccessFromAllInterfa
ces]
Enables Web access from any of the device's IP network
interfaces. The feature applies to HTTP and HTTPS protocols.
 [0] = (Default) Disable – Web access is only through the
OAMP interface.
 [1] = Enable - Web access is through any network interface.
Note:
 For the parameter to take effect, a device reset is required.
 Instead of using this parameter, you can use the Additional
Management Interfaces table to assign specific IP network
interfaces for management interfaces (as well as assign them
TLS Contexts). For more information, see Configuring
Additional Management Interfaces on page 72.