AudioCodes Mediant 500L - Page 1005

Version 7.2 1005 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
Password Change Interval
[WebUserPassChangeInterval]
Defines the duration (in minutes) of the validity of Web login
passwords. When this duration expires, the password of the Web
user must be changed.
The valid value is
0 to 100000, where 0 means that the password
is always valid. The default is 1140.
Note: The parameter is applicable only when using the Local
Users table, where the default value of the 'Password Age'
parameter in the Local Users table inherits the parameter's
value.
User Inactivity Timer
[UserInactivityTimer]
Defines the duration (in days) for which a user has not logged in
to the Web interface, after which the status of the user becomes
inactive and can no longer access the Web interface. These
users can only log in to the Web interface if their status is
changed (to New or Valid) by a Security Administrator or Master
user.
The valid value is 0 to 10000, where 0 means inactive. The
default is 90.
Note: The parameter is applicable only when using the Local
Users table.
Session Timeout
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in user
in the Web interface, after which the user is automatically logged
off the Web session. In other words, the session expires when
the user has not performed any operations (activities) in the Web
interface for the configured duration.
The valid value is 0, or 2 to 100000, where 0 means no timeout.
The default is 15.
Note: You can also configure the functionality per user in the
Local Users table (see ''Configuring Management User
Accounts'' on page 73), which overrides this global setting.
Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of failed login attempts, after
which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1 mean
immediate block. The default is 3.
Deny Authentication Timer
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to the Web
interface is denied from a specific IP address (for all users) when
the number of failed login attempts has exceeded the maximum.
This maximum is defined by the DenyAccessOnFailCount
parameter. Only after this time expires can users attempt to login
from this same IP address.
The valid value is 0 to 100000, where 0 means that login is not
denied regardless of number of failed login attempts. The default
is 60.
Display Last Login Information
[DisplayLoginInformation]
Enables display of user's login information on each successful
login attempt.
 [0] Disable (default)
 [1] Enable
[EnableMgmtTwoFactorAuthentic
ation]
Enables Web login authentication using a third-party, smart card.
 [0] = Disable (default)