AudioCodes Mediant 500L - Configuring IP Profiles

User's Manual 438 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Table 20-4: Allowed Video Coders Groups and Allowed Video Coders Tables Parameter
Descriptions
Parameter Description
Allowed Video Coders Groups Table
Index
allowed-video-coders-groups <index>
[AllowedVideoCodersGroups_Index]
Defines an index number for the new table row.
Note:
Each row must be configured with a unique
index.
Name
coders-group-name
[AllowedVideoCodersGroups_Name]
Defines a descriptive name, which is used when
associating the row in other tables.
The valid value is a string of up to 40 characters.
Note:
Each row must be configured with a unique
name.
Allowed Video Coders Table
Index
allowed-video-coders <group index/coder index>
[AllowedVideoCoders_AllowedVideoCodersIndex]
Defines an index number for the new table row.
Note:
Each row must be configured with a unique
index.
User Define Coder
user-define-coder
[AllowedVideoCoders_UserDefineCoder]
Defines a user-defined coder.
The valid value is a string of up to 24 characters
(case-insensitive). For example, "HD.123"
(without quotes).
Note: Each coder can be configured only once
per Allowed Video Coders Group.
20.4 Configuring IP Profiles
The IP Profiles table lets you configure up to 20 IP Profiles. An IP Profile is a set of
parameters with user-defined settings relating to signaling (e.g., SIP message terminations
such as REFER) and media (e.g., coder type). An IP Profile can later be assigned to
specific IP calls (inbound and/or outbound). Thus, IP Profiles provide high-level adaptation
when the device interworks between different IP entities, each of which may require
different handling by the device. For example, if a specific IP entity uses the G.711 coder
only, you can configure an IP Profile with G.711 for this IP entity.
To use your IP Profile for specific calls, you need to assign it to any of the following:
 IP Groups - see ''Configuring IP Groups'' on page 363
 Gateway application: Tel-to-IP routing rules - see Configuring Tel-to-IP Routing Rules
on page
509
 Gateway application: IP-to-Tel routing rules - see Configuring IP-to-Tel Routing Rules
on page
518
For the Gateway application: The device selects the IP Profile as follows:
 If you assign different IP Profiles (not default) to the same specific calls in all of the
above-mentioned tables, the device uses the IP Profile that has the highest preference
level (as set in the 'Profile Preference' parameter). If these IP Profiles have the same
preference level, the device uses the IP Profile that you assigned in the IP Groups
table.
 If you assign different IP Profiles to all of the above-mentioned tables and one table is
set to the default IP Profile, the device uses the IP Profile that is not the default.