User's Manual 958 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
60.1.1 Filtering IP Network Traces
You can filter Syslog and debug recording messages for IP network traces, by configuring
the 'Filter Type' parameter to IP Trace in the Logging Filters table. IP traces are used to
record any IP stream, according to destination and/or source IP address, or port and Layer-
4 protocol (UDP, TCP or any other IP type as defined by http://www.iana.com). Network
traces are typically used to record HTTP.
When the IP Trace option is selected, only the ‘Value’ parameter is applicable; the 'Syslog'
and 'Capture Type' parameters are not relevant. The 'Value' parameter configures the
Wireshark-like filtering expressions for your IP trace. The following Wireshark-like
expressions are supported:
Table 60-2: Supported Wireshark-like Expressions for 'Value' Parameter
Expression Description
ip.src, ip.dst Source and destination IP address
ip.addr IP address - up to two IP addresses can be entered
ip.proto IP protocol type (PDU) entered as an enumeration value
(e.g., 1 is ICMP, 6 is TCP, 17 is UDP)
udp, tcp, icmp, sip, ldap, http, https Single expressions for protocol type
udp.port, tcp.port Transport layer
udp.srcport, tcp.srcport Transport layer for source port
udp.dstport, tcp.dstport Transport layer for destination port
and, &&, ==, <, > Between expressions
Below are examples of configured expressions for the 'Value' parameter:
udp && ip.addr==10.8.6.55
ip.src==10.8.6.55 && udp.port>=5000 and udp.port<6000
ip.dst==10.8.0.1/16
ip.addr==10.8.6.40
For conditions requiring the "or" / "||" expression, add multiple table rows. For example, the
Wireshark condition "(ip.src == 1.1.1.1 or ip.src == 2.2.2.2) and ip.dst == 3.3.3.3" can be
configured using the following two table row entries:
1. ip.src == 1.1.1.1 and ip.dst == 3.3.3.3
2. ip.src == 2.2.2.2 and ip.dst == 3.3.3.3
Note:
• If the 'Value' parameter is undefined, the device records all IP traffic types.
• You cannot use ip.addr or udp/tcp.port together with ip.src/dst or
udp/tcp.srcport/dstport. For example, "ip.addr==1.1.1.1 and ip.src==2.2.2.2" is an
invalid configuration value.
To Next Page
Loading...
