AudioCodes Mediant 500L - Page 957

Version 7.2 957 Mediant 500L Gateway & E-SBC
User's Manual 60. Syslog and Debug Recording
Parameter Description
messages include only system Warnings and Errors.
 If you configure the parameter to Debug Recording Server
, you
can also include Syslog messages in the debug recording
packets sent to the debug recording server. To include Syslog
messages, configure the 'Log Type' parameter (see below) to
the relevant option.
Log Type
log-type
[LoggingFilters_CaptureType]
Defines the type of messages to include in the log file.
 [0] = (Default) Not configured. The option is applicable only for
sending Syslog messages to a Syslog server (i.e., 'Log
Destination' parameter is configured to Syslog Server).
 [1] Signaling = The option is applicable only to debug recording
(i.e., 'Log Destination' parameter is configured to Debug
Recording Server). The debug recording includes signaling
information such as SIP signaling messages, Syslog messages,
CDRs, and the device's internal processing messages.
 [2] Signaling & Media = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server). The debug recording includes
signaling, Syslog messages, and media (RTP/RTCP/T.38).
 [3] Signaling & Media & PCM = The option is applicable only to
debug recording (i.e., 'Log Destination' parameter is configured
to Debug Recording Server). The debug recording includes
signaling, Syslog messages, media, and PCM (voice signals
from and to TDM).
 [4] PSTN Trace = The option is applicable only to debug
recording (i.e., 'Log Destination' parameter is configured to
Debug Recording Server) and if the 'Filter Type' parameter is
configured to Trunk ID. The debug recording includes ISDN
traces.
 [5] CDR Only = Only CDRs are generated. The option is
applicable only if the 'Log Destination
' parameter is configured to
Syslog Server or Local Storage. When configured to Syslog
Server, only CDRs are included in the Syslog messages
(excluding all system logs and alerts) sent to the Syslog server.
 [6] Call Flow = The device sends SIP messages (in
XML format),
as they occur in real-
time, to OVOC for displaying SIP call dialog
sessions as call flow diagrams. For this functionality, you also
need to configure the 'Log Destination' parameter to Call Flow
Server. For enabling this functionality, see Enabling SIP Call
Flow Diagrams in OVOC on page
975.
Note:
 If you configure the 'Log Destination' parameter to Local
Storage, the 'Log Type' parameter must be configured to CDR
Only.
 The parameter is not applicable when the 'Fil
ter Type' parameter
is configured to IP Trace.
 To include Syslog messages in debug recording, it is
unnecessary to enable Syslog functionality.
Mode
mode
[LoggingFilters_Mode]
Enables and disables the rule.
 [0] Disable
 [1] Enable (default)