Version 7.2 1151 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
RTP DSCP for MLPP Routine
dscp-4-mlpp-rtn
[MLPPRoutineRTPDSCP]
Defines the RTP DSCP for MLPP Routine precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Priority
dscp-4-mlpp-prio
[MLPPPriorityRTPDSCP]
Defines the RTP DSCP for MLPP Priority precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Immediate
dscp-4-mlpp-immed
[MLPPImmediateRTPDSCP]
Defines the RTP DSCP for MLPP Immediate precedence call
level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash
dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Defines the RTP DSCP for MLPP Flash precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash
Override
dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash-
Override-Override
dscp-4-mlpp-flsh-ov-ov
[MLPPFlashOverOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
69.10.5.10 Call Cut-Through Parameters
The call cut-through parameters are described in the table below.
Table 69-51: Call Cut-Through Parameters
Parameter Description
Enable Calls Cut
Through
configure voip > sip-
definition settings >
calls-cut-through
Global parameter enabling FXS endpoints to receive incoming IP calls
while the port is in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_IP2TelCutThroughCallBehavior). For a detailed
description of the parameter and for configuring the functionality in the Tel
Profiles table, see Configuring Tel Profiles on page 471.
To Next Page
Loading...
