AudioCodes Mediant 500L - Supplementary Services Parameters; Caller ID Parameters

Version 7.2 1129 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
voice-mail-setting > disc-call-
dig-ptrn
[TelDisconnectCode]
The valid range is a 25-character string.
Digit To Ignore Digit Pattern
configure voip > gateway
voice-mail-setting > dig-to-
ignore-dig-pattern
[DigitPatternDigitToIgnore]
Defines a digit pattern that if received as Src (S) or Redirect (R)
numbers is ignored and not added to that number.
The valid range is a 25-character string.
69.10.5 Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
69.10.5.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Table 69-42: Caller ID Parameters
Parameter Description
Caller ID Permissions Table
Caller ID Permissions
configure voip > gateway dtmf-supp-
service supp-service-settings > enable-
caller-id
[EnableCallerID]
This table parameter enables (per port) Caller ID generation
(FXS interfaces) and detection (FXO interfaces).
The format of the ini file table parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index =
EnableCallerID_IsEnabled, EnableCallerID_Module,
EnableCallerID_Port;
[\EnableCallerID]
Where,

 Module = Module number, where 1 denotes the module
in Slot 1.
 Port = Port number, where 1 denotes Port 1 of a module.
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of
Module 3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of
Module 3)
For more information
, see Configuring Caller ID Permissions
on page 620.
Note:
 The indexing of the parameter starts at 0.
 The parameter is applicable only to analog interfaces.
Caller Display Information Table
Caller Display Information
configure voip > gateway analog caller-
This table parameter enables the device to send Caller ID
information to the IP side when a call is made. The called