AudioCodes Mediant 500L - Syslog, CDR and Debug Parameters

User's Manual 1032 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
id
[TestCallID]
defined.
Note:
 The parameter is only for testing incoming calls destined to this prefix
number.
 This feature is applicable to all applications (Gateway and SBC).
Test Call Rules Table
Test Call Rules
configure troubleshoot
>test-call test-call-table
[Test_Call]
Defines Test Call rules.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupName,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SIPInterfaceName, Test_Call_ApplicationType,
Test_Call_AutoRegister, Test_Call_UserName, Test_Call_Password,
Test_Call_CallParty, Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For more information, see ''Configuring Test Call Endpoints'' on page
983.
69.3.3 Syslog, CDR and Debug Parameters
The Syslog, CDR and debug parameters are described in the table below.
Table 69-19: Syslog, CDR and Debug Parameters
Parameter Description
Enable Syslog
configure troubleshoot >
syslog > syslog
[EnableSyslog]
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.
 [0] Disable (default)
 [1] Enable
Note:
 If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).
 Syslog messages may increase the network traffic.
 To configure Syslog SIP message logging levels, use the
GwDebugLevel parameter.
Syslog Server IP
configure troubleshoot >
syslog > syslog-ip
[SyslogServerIP]
Defines the IP address (in dotted-decimal notation) of the computer
on which the Syslog server is running. The Syslog server is an
application designed to collect the logs and error messages
generated by the device.
The default IP address is 0.0.0.0.
Syslog Server Port
configure troubleshoot >
syslog > syslog-port
[SyslogServerPort]
Defines the UDP port of the Syslog server.
The valid range is 0 to 65,535. The default port is 514.
CDR Server IP Address Defines the destination IP address to where CDR logs are sent.