AudioCodes Mediant 500L - Page 1033

Version 7.2 1033 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
configure troubleshoot > cdr >
cdr-srvr-ip-adrr
[CDRSyslogServerIP]
The default value is a null string, which causes CDR messages to be
sent with all Syslog messages to the Syslog server.
Note:
 The CDR messages are sent to UDP port 514 (default Syslog
port).
 This mechanism is active only when Syslog is enabled (i.e., the
parameter EnableSyslog is set to 1).
CDR Report Level
configure troubleshoot > cdr >
cdr-report-level
[CDRReportLevel]
Enables media and signaling-related CDRs to be sent to a Syslog
server and defines the call stage at which they are sent.
 [0] None = (Default) CDRs are not used.
 [1] End Call = CDR is sent to the Syslog server at the end of each
call.

[2] Start & End Call = CDR report is sent to Syslog at the start and
end of each call.
 [3] Connect & End Call = CDR report is sent to Syslog at
connection and at the end of each call.
 [4] Start & End & Connect Call = CDR report is sent to Syslog at
the start, at connection, and at the end of each call.
Note:
 For the SBC application, the parameter enables only signaling-
related CDRs. To enable media-related CDRs for SBC calls, use
the MediaCDRReportLevel parameter.
 The CDR Syslog message complies with RFC 3164 and is
identified by: Facility = 17 (local1) and Severity = 6
(Informational).
 This mechanism is active only when Syslog is enabled (i.e., the
parameter EnableSyslog is set to 1).
Media CDR Report Level
configure troubleshoot > cdr >
media-cdr-rprt-level
[MediaCDRReportLevel]
Enables media-related CDRs of SBC calls to be sent to a Syslog
server and defines the call stage at which they are sent.
 [0] None = (Default) No media-related CDR is sent.
 [1] End Media = Sends a CDR only at the end of the call.
 [2] Start & End Media = Sends a CDR once the media starts. In
some calls it may only be after the call is established, but in other
calls the media may start at ringback tone. A CDR is also sent
upon termination (end) of the media in the call.
 [3] Update & End Media = Sends a CDR when an update occurs
in the media of the call. For example, a call starts and a ringback
tone occurs, a re-INVITE is sent for a fax call and as a result, a
CDR with the MediaReportType field set to "Update" is sent, as
the media was changed from voice to T.38. A CDR is also sent
upon termination (end) of the media in the call.
 [4] Start & End & Update Media = Sends a CDR at the start of the
media, upon an update in the media (if occurs), and at the end of
the media.
Note:
 The parameter is applicable only to the SBC application.
 To enable CDR generation as well as enable signaling-related
CDRs, use the CDRReportLevel parameter.
Local Storage Max File Size Defines the size (in kilobytes) of each stored CDR file. Once the file
size is reached, the device creates a new file for subsequent CDRs,