AudioCodes Mediant 500L - Page 1137

Version 7.2 1137 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
Enable Call Forward
configure voip > gateway
dtmf-supp-service supp-
service-settings > call-
forward
[EnableForward]
Enables call forwarding.
 [0] Disable
 [1] Enable (Default)
For FXS interfaces, the Call Forward table (FwdInfo parameter) must be
configured to us
e the Call Forward feature. The device uses SIP REFER
messages for call forwarding.
Note:
 To use this service, the devices at both ends must support call
forarding.
 For the device to respond to SIP 3xx responses with a new SIP
request (forwarding the original request), configure the parameter to
Enable.
Call Forwarding Table
Call Forwarding Table
configure voip > gateway
analog call-forward
[FwdInfo]
Defines call forwarding of IP-to-Tel calls (using SIP 302 response) to
other device ports or an IP destination, based on the device's port to
which the call was originally routed.
The format of the ini file table parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,

 Module = Module number, where 1 denotes the module in Slot 1.
 Port = Port number, where 1 denotes Port 1 of a module.
For example:
 Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;
 Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
For more information, see Configuring Call Forward on page 618.
Note: The parameter is applicable only to analog interfaces.
Call Forward Reminder Ring Parameters
Note:
 These parameters are applicable only to FXS interfaces.
 For a description of this feature, see Call Forward Reminder Ring on page 575.
Enable NRT Subscription
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-
subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.
 [0] Disable (default)
 [1] Enable
AS Subscribe IPGroupID
configure voip > gateway
dtmf-supp-service supp-
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).