AudioCodes Mediant 500L - Page 1097

Version 7.2 1097 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
''Alternative Routing Based on IP Connectivity'' on page 526.
SIP Message Manipulations Table
Message Manipulations
configure voip > message
message-manipulations
[MessageManipulations]
Defines manipulation rules for SIP header messages.
The format of the ini file table parameter is as follows:
[ MessageManipulations]
FORMAT MessageManipulations_Index =
MessageManipulations_ManSetID,
MessageManipulations_MessageType,
MessageManipulations_Condition,
MessageManipulations_ActionSubject,
MessageManipulations_ActionType,
MessageManipulations_ActionValue,
MessageManipulations_RowRole;
[\MessageManipulations]
For example, the below configuration changes the user part of the SIP
From header to 200:
MessageManipulations 1 = 0, Invite.Request, , Header.From.Url.User,
2, 200, 0;
For more information, see Configuring SIP Message Manipulation on
page 415.
Message Policies Table
Message Policies
configure voip > message
message-policy
[MessagePolicy]
Defines SIP message policy rules for blocking (blacklist) unwanted
incoming SIP messages or allowing (whitelist) receipt of desired
messages.
The format of the ini file table parameter is as follows:
[MessagePolicy]
FORMAT MessagePolicy_Index = MessagePolicy_Name,
MessagePolicy_MaxMessageLength,
MessagePolicy_MaxHeaderLength, MessagePolicy_MaxBodyLength,
MessagePolicy_MaxNumHeaders, MessagePolicy_MaxNumBodies,
MessagePolicy_SendRejection, MessagePolicy_MethodList,
MessagePolicy_MethodListType, MessagePolicy_BodyList,
MessagePolicy_BodyListType,
MessagePolicy_UseMaliciousSignatureDB;
[/MessagePolicy]
For more information, see Configuring SIP Message Policy Rules.
configure voip > sip-
definition settings >
message-policy-reject-
response-type
[MessagePolicyRejectResp
onseType]
Defines the SIP response code that the device sends when it rejects an
incoming SIP message due to a matched Message Policy in the
Message Policies table, whose ‘Send Reject’
(MessagePolicy_SendRejection) parameter is configured to Policy
Reject [0].
The default is 400 "Bad Request".
To configure Message Policies, see Configuring SIP Message Policy
Rules.
Pre-Parsing Manipulation Sets Table
Pre-Parsing Manipulation
Sets
configure voip >
Defines Pre-parsing Manipulation Sets.
The format of the ini file table parameter is as follows:
[ PreParsingManipulationSets ]