AudioCodes Mediant 500L - Page 1132

User's Manual 1132 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
cpc=operator 5 Operator
cpc=data 6 Data call
cpc=payphone 7 Payphone user
Note:
 The parameter is applicable only to FXS interfaces.
 For the parameter to be enabled, you must also set the
parameter EnableCallingPartyCategory to 1.
[EnableCallerIDTypeTwo] Disables the generation of Caller ID type 2 when the phone
is off-hooked. Caller ID type 2 (also known as off-hook
Caller ID) is sent to a currently busy telephone to display the
caller ID of the waiting call.
 [0] = Caller ID type 2 isn't played.
 [1] = (Default) Caller ID type 2 is played.
Note: The parameter is applicable only to FXS interfaces.
configure voip > interface fxs-fxo >
caller-id-timing-mode
[AnalogCallerIDTimingMode]
Determines when Caller ID is generated.
 [0] = (Default) Caller ID is generated between the first
two rings.
 [1] = The device attempts to find an optimized timing to
generate the Caller ID according to the selected Caller ID
type.
Note:
 The parameter is applicable only to FXS interfaces.
 If the parameter is set to 1 and used with distinctive
ringing, the Caller ID signal doesn't
change the distinctive
ringing timing.
 For the parameter to take effect, a device reset is
required.
configure voip > interface fxs-fxo >
bellcore-callerid-type-one-sub-standard
[BellcoreCallerIDTypeOneSubStandard
]
Determines the Bellcore Caller ID sub-standard.
 [0] = (Default) Between rings.
 [1] = Not ring related.
Note:
 For the parameter to take effect, a device reset is
required.
 The parameter is applicable only to FXS interfaces.
configure voip > interface fxs-fxo > etsi-
callerid-type-one-sub-standard
[ETSICallerIDTypeOneSubStandard]
Determines the ETSI FSK Caller ID Type 1 sub-standard
(FXS only).
 [0] = (Default) ETSI between rings.
 [1] = ETSI before ring DT_AS.
 [2] = ETSI before ring RP_AS.
 [3] = ETSI before ring LR_DT_AS.
 [4] = ETSI not ring related DT_AS.
 [5] = ETSI not ring related RP_AS.
 [6] = ETSI not ring related LR_DT_AS.
Note:
 For the parameter to take effect, a device reset is