AudioCodes Mediant 500L - Page 1173

Version 7.2 1173 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
[UserToUserHeaderFormat]
header and the ISDN User-to-User (UU) IE data.
 [0] = (Default) SIP header format: X-UserToUser.
 [1] = SIP header format: User-to-User with Protocol Discriminator
(pd) attribute (according to IETF Internet-Draft draft-johnston-
sipping-cc-uui-04). For example:
User-to-
User=3030373435313734313635353b313233343b3834;pd=4
 [2] = SIP header format: User-to-User with encoding=hex at the
end and pd embedded as the first byte (according to IETF Internet-
Draft draft-johnston-sipping-cc-uui-03). For example:
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex
where "04" at the beginning of this message is the pd.
 [3] = Interworks the SIP User-to-User header containing text format
to ISDN UUIE in hexadecimal format, and vice versa. For example:
SIP Header in text format:
User-to-User=01800213027b712a;NULL;4582166;
Translated to hexadecimal in the ISDN UUIE:
303138303032313330323762373132613b4e554c4c3b343538
323136363b
The Protocol Discriminator (pd) used in UUIE is "04" (IUA
characters).
Note: The parameter is applicable for Tel-to-IP and IP-to-Tel calls.
Remove CLI when
Restricted
rmv-cli-when-restr
[RemoveCLIWhenRestricted
]
Determines (for IP-to-Tel calls) whether the Calling Number and
Calling Name IEs are removed from the ISDN Setup message if the
presentation is set to Restricted.
 [0] No = (Default) IE's are not removed.
 [1] Yes = IE's are removed.
Remove Calling Name
rmv-calling-name
[RemoveCallingName]
Enables the device to remove the Calling Name from SIP-to-ISDN
calls for all trunks.
 [0] Disable = (Default) Does not remove Calling Name.
 [1] Enable = Removes Calling Name.
Note: Some PSTN switches / PBXs may not be configured to support
the receipt of the “Calling Name” information. These switches might
respond to an ISDN Setup message (including the Calling Name) with
an ISDN "REQUESTED_FAC_NOT_SUBSCRIBED" failure. The
parameter can be set to Enable (1) to remove the “Calling Name” from
SIP-to-ISDN calls and allow the call to proceed.
Remove Calling Name
configure voip > interface bri
> rmv-calling-name
[RemoveCallingNameForTru
nk_x]
Enables the device to remove the Calling Name for SIP-to-ISDN calls,
per trunk.
 [-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.
 [0] Disable = Does not remove Calling Name.
 [1] Enable = Remove Calling Name.
Note: The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Progress Indicator to ISDN Determines the Progress Indicator (PI) to ISDN per trunk.