AudioCodes Mediant 500L - Page 1185

Version 7.2 1185 Mediant 500L Gateway & E-SBC
User's Manual 69. Configuration Parameters Reference
Parameter Description
Note:
 The parameter is applicable to analog interfaces.
 You can define the Hotline duration per FXS/FXO port using
the Automatic Dialing table.
Reorder Tone Duration
configure voip > gateway analog
fxo-setting > reorder-tone-duration
[TimeForReorderTone]
Global parameter defining the duration (in seconds) that the
device plays a busy or reorder tone before releasing the line.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_TimeForReorderTone). For a detailed
description of the parameter and for configuring the
functionality in the Tel Profiles table, see ''Configuring Tel
Profiles'' on page 471.
Note: If the functionality is configured for a specific Tel Profile,
the settings of the global parameter is ignored for calls
associated with the Tel Profile.
Cut Through Reorder Tone
Duration
cut-thru-reord-dur
[CutThroughTimeForReOrderTone]
Defines the duration (in seconds) of the reorder tone played to
the Tel side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call
is immediately answered if the FXS is off-hooked (for analog
interfaces) or the PSTN is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no reorder
tone is played).
Note: To enable the Cut-Through feature, use the CutThrough
(for FXS channels) parameter.
Enable Comfort Tone
comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone
Type #18) to the FXS/FXO endpoint after a SIP INVITE is sent
and before a SIP 18x response is received.
 [0] Disable (default)
 [1] Enable
Note: The parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration] Defines the duration (in seconds) for which the offhook warning
tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Note:
 A negative value indicates that the tone is played infinitely.
 The parameter is applicable only to analog interfaces.
Time Before Reorder Tone
time-b4-reordr-tn
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates
call) until the device starts playing a reorder tone to the FXS
phone.
The valid range is 0 to 60. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
Play Busy Tone to Tel
configure voip > sip-definition
settings > play-bsy-tone-2tel
[PlayBusyTone2ISDN]
Enables the device to play a busy or reorder tone to the PSTN
after a Tel-to-IP call is released.
 [0] Don't Play = (Default) Immediately sends an ISDN
Disconnect message.
 [1] Play when Disconnecting = Sends an ISDN Disconnect
message with PI = 8 and plays a busy or reorder tone to the
PSTN (depending on the release cause).