AudioCodes Mediant 500L - Page 1202

User's Manual 1202 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
For more information, see ''Configuring Trunk Group Settings''
on page 503.
Channel Select Mode
ch-select-mode
[ChannelSelectMode]
Defines the method for allocating incoming IP-to-Tel calls to a
channel. The parameter applies to the following:
 All Trunk Groups configured without a channel select mode
in the Trunk Group Settings table (see ''Configuring Trunk
Group Settings'' on page 503).
 All channels and trunks configured without a Trunk Group
ID.
for all Trunk Groups channels that are configured without a
Trunk Group ID,.
 [0] By Dest Phone Number
 [1] Cyclic Ascending (default)
 [2] Ascending
 [3] Cyclic Descending
 [4] Descending
 [5] Dest Number + Cyclic Ascending.
 [6] By Source Phone Number
 [7] Trunk Cyclic Ascending
 [8] Trunk & Channel Cyclic Ascending
 [10] Select Trunk By Supplementary Service Table
 [11] Dest Number + Ascending
For a detailed description of the parameter's options, see
''Configuring Trunk Group Settings'' on page 503.
Default Destination Number
configure voip > gateway dtmf-supp-
service dtmf-and-dialing > ddflt-dest-
nb
[DefaultNumber]
Defines the default destination phone number, which is used if
the received message doesn't contain a called party number
and no phone number is configured in the Trunk Group table
(see Configuring the Trunk Groups on page 501). The
parameter is used as a starting number for the list of channels
comprising all the device's Trunk Groups.
The default is 1000.
Source IP Address Input
configure voip > gateway routing
settings > src-ip-addr-input
[SourceIPAddressInput]
Determines which IP address the device uses to determ
ine the
source of incoming INVITE messages for IP-to-Tel routing.
 [-1] = (Default) Auto Decision - the parameter is
automatically set to SIP Contact Header (1).
 [0] SIP Contact Header = The IP address in the Contact
header of the incoming INVITE message is used.
 [1] Layer 3 Source IP = The actual IP address (Layer 3)
from where the SIP packet was received is used.